Jeep 2014 Cherokee - User Guide Bedienungsanleitung PDF herunterladen (Seite 24)

• The center seating position in this vehicle has a single dedicated anchorage. Use

anchorages 3 and 4 to install a child seat in the center position. Do not use

anchorages 2 and 3 to install a child seat. If you are installing three child

restraints, you must use the seatbelt to install the center child restraint and you

must use the LATCH anchors for the outboard position on the left side. You can use

either the LATCH anchors or the vehicle’s seat belt for installing the child seat in

the outboard position on the right side. See the vehicle owner’s manual for more

information about center LATCH.

Installing The Child Restraint Using The LATCH Lower Anchors

NOTE:

Never “share” a LATCH anchorage with two or more child restraints.

1. Loosen the adjusters on the lower straps and on the tether strap of the child seat

so that you can more easily attach the hooks or connectors to the vehicle

anchorages.

2. Attach the lower hooks or connectors of the child restraint to the lower anchorages

in the selected seating position.

3. If the child restraint has a tether strap, connect it to the top tether anchorage. See

below for directions to attach a tether anchor.

4. Tighten all of the straps as you push the child restraint rearward and downward

into the seat. Remove slack in the straps according to the child restraint

manufacturer’s instructions.

5. Test that the child restraint is installed tightly by pulling back and forth on the

child seat at the belt path. It should not move more than 1 inch (25.4 mm) in any

direction.

Lower Child Seat Anchors

GETTING STARTED

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 203 204

Keine Kommentare

Jeep 2014 Cherokee - User Guide Bedienungsanleitung Seite 24