Jeep 2014 Cherokee - User Guide Bedienungsanleitung PDF herunterladen (Seite 157)

If the tire does not inflate to at least 26 psi (1.8 Bar) pressure within 15 minutes:

The tire is too badly damaged. Do not attempt to drive the vehicle further. Call for

assistance.

NOTE:

If the tire becomes over-inflated, press the Deflation Button to reduce the tire

pressure to the recommended inflation pressure before continuing.

If the tire inflates to the recommended pressure or is at least 26 psi (1.8 Bar) pressure

within 15 minutes:

1. Press the Power Button (4) to turn off the TIREFIT kit.

2. Remove the Speed Limit sticker from the top of the Sealant Bottle (1) and place

the sticker on the instrument panel.

3. Immediately disconnect the Sealant Hose (6) from the valve stem, reinstall the

cap on the fitting at the end of the hose, and place the TIREFIT kit in the vehicle

storage location. Quickly proceed to (D) “Drive Vehicle.”

(D) Drive Vehicle:

Immediately after injecting sealant and inflating the tire, drive the vehicle 5 miles

(8 km) or 10 minutes to ensure distribution of the TIREFIT Sealant within the tire. Do

not exceed 55 mph (88 km/h).

(E) After Driving:

Pull over to a safe location. Refer to “Whenever You Stop to Use TIREFIT” before

continuing.

1. Turn the Mode Select Knob (5) to the Air Mode position.

2. Uncoil the Air Pump Hose (7) (black in color) and screw the fitting at the end of

hose (7) onto the valve stem.

3. Uncoil the power plug and insert the plug into the vehicles 12 Volt power outlet.

4. Check the pressure in the tire by reading the Pressure Gauge (3).

If tire pressure is less than 19 psi (1.3 Bar), the tire is too badly damaged. Do not attempt

to drive the vehicle further. Call for assistance.

WHAT TO DO IN EMERGENCIES

155

1 2 ... 152 153 154 155 156 157 158 159 160 161 162 ... 203 204

Keine Kommentare

Jeep 2014 Cherokee - User Guide Bedienungsanleitung Seite 157