Jeep 2014 Cherokee - User Guide Bedienungsanleitung PDF herunterladen (Seite 126)

NOTE:

You have 30 seconds in which to initiate the next step after the LEARN button has

been pressed.

6. Return to the vehicle and press the programmed HomeLink

button twice

(holding the button for two seconds each time). If the device is plugged in and

activates, programming is complete.

NOTE:

If the device does not activate, press the button a third time (for two seconds) to

complete the training.

7. To program the remaining two HomeLink

buttons, repeat each step for each

remaining button. DO NOT erase the channels.

Programming A Non-Rolling Code

NOTE:

For programming Garage Door Openers manufactured before 1995.

1. Turn the ignition switch to the ON/RUN position.

2. Place the hand-held transmitter 1 to 3 inches (3 to 8 cm) away from the

HomeLink

button you wish to program while keeping the HomeLink

indicator

light in view.

3. Simultaneously press and hold both the HomeLink

button you want to program

and the hand-held transmitter button.

4. Continue to hold both buttons and observe the indicator light. The HomeLink

indicator will flash slowly and then rapidly after HomeLink

has received the

frequency signal from the hand-held transmitter. Release both buttons after the

indicator light changes from slow to rapid.

5. Press and hold the programmed HomeLink

button and observe the indicator

light. If the indicator light stays on constantly, programming is complete and the

garage door (or device) should activate when the HomeLink

button is pressed.

6. To program the two remaining HomeLink

buttons, repeat each step for each

remaining button. DO NOT erase the channels.

ELECTRONICS

124

1 2 ... 121 122 123 124 125 126 127 128 129 130 131 ... 203 204

Keine Kommentare

Jeep 2014 Cherokee - User Guide Bedienungsanleitung Seite 126